Adjust bull pinion shaft bearings to a free rolling fit with zero end play by varying the number of shims (20 and 21- Fig. Long hub of gear should face toward wheel.Īdjust wheel axle shaft bearings to a free rolling fit with no end play by varying the number of shims located on inner end of shaft.Ģ00. The oil seal (17) (lip facing bull gear) and/or bearings can be renewed at this time. Support bull gear and bump wheel axle shaft out of bull gear and housing. Working through bull gear housing opening remove bull gear positioning snap ring (12). Remove wheel axle shaft bearing dust cap, cap screw, washer (5) and shims. 131), bull gear (13) and/or wheel axle shaft oil seal (17) or bearings (7 and 16), proceed as follows: Drain bull gear housing then remove housing pan and rear wheel and tire unit. To renew either wheel axle shaft (18 Fig. Renew Wheel Axle Bearings and/or Bull Gear. 131) interposed between wheel axle shaft retaining cap screw washer (5) and inner end of shaft.ġ99. Adjust bearings to a free rolling fit with no end play by varying the number of shims (6 Fig. Idle speed stop screw on the carburetor throttle should be adjusted to provide the correct low idle engine speed.ġ98. Place controls in operating position by completely opening the choke.ġ01. A slightly richer adjustment (counter-clockwise until speed drops slightly) may be desirable for a particular fuel or operating condition. 61) until the highest engine speed is obtained.
Immediately after the engine is started, bring the throttle to the fully open position and with the choke in the fully closed position, rotate the starting screw(N- Fig.
Allis chalmers d10 serial numbers plus#
The Ensign model Mg 1 carburetor and model W regulator have three points of mixture adjustment, plus an idle stop screw.ġ00. Like other LP-Gas systems, this system is designed to operate with the fuel tank no more than 80% filled. The LP-Gas system available is designed and built by Ensign Carburetor Co.
Allis chalmers d10 serial numbers manual#
This repair manual includes wiring diagrams for all Allis-Chalmers tractors listed, except Model 175.īook Excerpt: Allis-Chalmers Repair Manual D-10, D-12, D-14, D-15, D-17, 160, 170, 175 The Allis-Chalmers Repair Manual D-10, D-12, D-14, D-15, D-17, 160, 170, 175 covers the following tractors: